If that is the splitter its a poor diagram, but no matter as Rimmers are out of stock as expected.
Yes you will need one as i did, you could get away without and tie grip the undertray to the bumper but much better finish with the splitter and Rover Breakers wont want much for one, if you have headlight washers or plan to get any the tubing runs inside the splitter too# btw item 7 in the Russian diagram above which were also hard to come by are now available at Lakeland Minis i understand |
If they are available through South Lakeland mini centre and people don't want to risk postage I can collect and drop off at POL or the National?
|
I have the upper bracket, but thank you. It's the splitter gizmo I'm unclear about. Is this similar to the Seat Leon thingy people are fitting?
TC |
Quote:
as said as well as the look of it you will need it if doing the premium bumper mod as it fits between undertray and bumper, it is one piece that goes across the front end but note how it is deeper at both ends than in the middle http://i299.photobucket.com/albums/m...ictures883.jpg |
It is item 2 TC
DPF000050 Quote:
|
Quote:
A bit off track, but that is a stunning looking car. An MG ZT coupe would be even better for me too. :drool4: |
Quote:
|
Think I was getting confused, no rubber splitter but there is a piece of plastic trim between the undertray and bumper due to the bumper sitting a few inches lower
|
I think its item 14 on the V8 breahttp://www.rimmerbros.co.uk/ProductI...GRID004309.gifkdown I have one fitted to my ZTT 260and as Trebor said Rover breaker have them.
Rimmers part no http://www.rimmerbros.co.uk/Item--i-DPF000050 listed as nolonger available. Quote:
|
TC do you have the link for the 75/zt Russian site please.:bowdown:
|
All times are GMT. The time now is 13:45. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd