Also, on mine, I couldn't re-use the rubber band that Rover use to hold the gaiter to the handbrake handle, as I'd fitted a Freelander handle, and there wasn't the groove. Well there might have been, but I'd cut it off as the handle was too long. So I used the thinnest cable tie I could find in my workshop, and this has held it fine for a couple of years now.
just take your time doing the gluing, as IIRC, it's a bit fiddly, particularly around the front, unfortunatelty where it's most visible.
HTH
malcolm
BTW, Eamonn, I've added the Chrome Trim Christopher suggested for the door switches, around the hazard/doorlock switch surround, to match the gear lever gaiter base. (After I'd taken the avatar pic, obviously......)