View Single Post
Old 18th June 2009, 19:40   #7
ferryjambo
Regular poster
 
rover 75 club cdt se

Join Date: Jun 2008
Location: South Queensferry. Scotland
Posts: 31
Thanks: 0
Thanked 0 Times in 0 Posts
Default Thanks

thanks everyone,
i tried splicing the wires using hans instructions, the unit powers up & cycles the cd's ok, but my screens says "No Cd changer"... I was carefull to connect the kbus/control wires correctly between the changer & sat nav but it does'nt see/speak to it ??..

Here's my unit..


and the back showing the wiring diagram..




as you can see from the 3rd image i thought pin 17 (control) on the blue iso plug was the kbus.. I think i should have connected the kbus wire from the alpine onto the Nos.3 pin of the bottom iso marked ( K. Line ).. I'll try this tomorrow & see if this enables the changer & sat nav unit to "talk" to each other...
ferryjambo is offline   Reply With Quote