[jubbarelly]

Originally Posted by Rsnail

I got a few questions regarding the installation:

1. The steering wheel cables are also in the back of the original symphony unit? And where do I have to cut them from in order to solder them to the ones that came with the ISO cable that you provided me for my unit?

The steering controls are the Blue/Purple cable on pin 3 and Blue/Orange cable on pin 2 of the grey ISO plug. I think you have to connect an earth to pin 2 on the grey ISO plug, key 1 on the stereo loom goes to pin 3 (Blue/Purple) on the grey ISO plug.

2. How can I feed the GPS Antenna up to the windscreen?

When I do an install, I put the GPS receiver under the drivers side A pillar trim and feed the wire down and under the steering column then back up into the headunit hole (there is a hole just big enough to put your hand in. Very easy to do. Thats the best place to conceal it and get a good GPS lock.

3. How can I feed the USB cables to the glove box?

The glove box doesnt have any holes so you will have to drill / cut some into the side of it if you want to have the USB leads in there. I would extend the USB cable with a USB extension lead and run it to the centre armrest.

4. How can I connect the illumination cable from the ISO cable provided?

This doesnt need to be connected, just leave the CANBUS box plugged into the stereo loom.

5. What is the P. ANT cable (blue one also coming from the ISO connector) and do I have to connect that to something too?

Again this doesnt need to be connected and can be left alone.

Thanks
Jub