Part two :
44-r75bmr close up, work the teeth until the washer comes free, take care here and remember it is under pressure form the spring underneath
45-r75bmr separated parts, newly modified spigot, spring and now unusable retaining washer
46-r75bmr using a hacksaw, cut a groove the thickness of the blade, 3mm's in from each end
47-r75bmr close up
48-r75bmr here's the three pence cure I was talking about, fix one cir-clip at the keep end of the spigot
49-r75bmr insert spigot into the door fixing section of the mirror assembly
50-r75bmr just to give an idea of how it all fits together, leave the two plastic washers in this position, but do not assemble remaining parts at this stage
51-r75bmr in order to get that pesky spring back in its home, compress and tie down as shown and again opposite
52-r75bmr spring pushed firmly all the way to the bottom of the chamber
53-r75bmr re-assemble the inner assembly with pivotal spigot to the main mirror body, because we drilled away the retaining rivets, fix with small self tappers
54-r75bmr turn over unit and secure second cir-clip
55-r75bmr close up
56-r75bmr cut away string ties from the spring
57-r75bmr et voilá mirror pivots as it should
58-r75bmr this way
59-r75bmr and that way !
60-r75bmr showing position of the mirror motor, but first reconnect the mirror rocker, using thin long nose pliers to hold the yellow pins, push the rocker sockets firmly home
61-r75bmr rocker and motor re-united
62-r75bmr connect electrics
63-r75bmr as I said, the plastic clips easily break, self tappers hold the motor firmly in place
64-r75bmr the tricky bit is clipping the mirror glass onto the rocker, some say the reversal of removal is the answer
65-r75bmr if this was so, then clip the mirror into the far end of the rocker, then the clip end of the rocker, in reality I found it much easier to do this in reverse, clip in first, then firmly push the mirror home
66-r75bmr mirror safely back on the rocker, intact !
67-r75bmr reconnect electrics
68-r75bmr replace rear decorative scull cap finisher
69-r75bmr cap firmly home
70-r75bmr all done ready to go back on the car, three pence cir-clips are us !
71-r75bmr folding as it should
72-r75bmr replace inner door trim finisher
73-r75bmr tape rattling door lock pin, before putting the door card back on, thumping with side of fist to get the clips home