The 75 and ZT Owners Club Forums - View Single Post

captaintess · 30th October 2012, 08:41

Just for the record, the cam shafts are NOT inter changeable, the inlet camshaft cannot be used for the exhaust camshaft! the lobes are different, if the end of the camshaft has broken the more likely the woodruft key on the pulley has perished or the timing belt has stretched, the best way round this is the replace the camshaft, pulley and the woodruft key and don't forget to replace the pulley bolts fitting them with thread locking chemical ! i've done three of these engines and they are a total nightmare! normally charge about £700. Or buy a second hand engine!

30th October 2012, 08:41	#22
captaintess Newbie Rover 75 V6 Join Date: May 2012 Location: Maidstone Posts: 9 Thanks: 0 Thanked 0 Times in 0 Posts	Rover 75 timing belt Just for the record, the cam shafts are NOT inter changeable, the inlet camshaft cannot be used for the exhaust camshaft! the lobes are different, if the end of the camshaft has broken the more likely the woodruft key on the pulley has perished or the timing belt has stretched, the best way round this is the replace the camshaft, pulley and the woodruft key and don't forget to replace the pulley bolts fitting them with thread locking chemical ! i've done three of these engines and they are a total nightmare! normally charge about £700. Or buy a second hand engine!