Hi,John
If you can lead some electric measurements;
there are two important informations.
1 Low pressure fuel sensor (fuel filter housing):
for 2.6 bars,you must have about 4 volts on the yellow/blue wire
(sensor disconnected,engine can start)
2 Fuel rail pressure sensor(at the end of the fuel rail)
(blue/black wire)
you have:1.3 volts at idle and 2 volts at 3000 rpm.
(sensor disconnected,one can start the engine too)
And don't forget ;during cranking,the tachometer move slighty
(Showing crankshaft sensor is OK)
Mike
Last edited by FrenchMike; 31st August 2010 at 17:20..
|