From memory - with our Wyoming - you needed the 12 V system turned on for the lights to work. Your board shows the 12 V system is turned off as the switch is in position O and the meter is reading zero.
Turn the switch to "on" and the meter should read 12 V - when connected to mains it should read about 14 V. I think when the 12 V system is on - the lights should work.
I also believe there was a switch that turned all the lights off by the door. So rather than going round turning off each light individually when you went out - you could simply use this switch to turn out the lot.
When you came back - one switch turned all your lights back on again.
You may want to check this switch - if you have one - is in the correct position.
Hope this helps.
|