|
||
|
7th November 2006, 09:24 | #1 |
Newbie
Rover 75 Saloon CDT Auto Join Date: Nov 2006
Location: Cardiff
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Sun Visors
When I want to use the sun visors and pull them down from the stowed position, the visor generally ends up on the floor of the car or my lap.
Where the visor frame goes into the roof lining there does not seem be anything holding it in place. (Not the best description, but the best I can do for now) Has anybody got any ideas as to how I can secure the visors so that they don't detach themselves and end upon the floor everytime I want to use them. Thanks James |
7th November 2006, 09:47 | #2 |
This is my second home
ZT400 Join Date: Oct 2006
Location: Ellesmere
Posts: 5,948
Thanks: 0
Thanked 43 Times in 29 Posts
|
Hi James I have only done this once so may be wrong
It is clipped on the non swivel side but screwed in at the swivel there is a little square cover over where the screw should be, have you taken this out to ensure the screw or the fitting it goes into is intact? I can't remember is the screw expands the plastic to retain it or screws into part of the roof but once removed all should be obvious to you HTH |
7th November 2006, 09:48 | #3 |
This is my second home
Rover 75 V8 Join Date: Oct 2006
Posts: 3,448
Thanks: 0
Thanked 206 Times in 32 Posts
|
James,
Do the brackets and everything fall out of the roof lining? Mike
__________________
Mike [SIGPIC][/SIGPIC] |
7th November 2006, 10:18 | #4 |
This is my second home
Volvo C70 Convertible and JZR 3 wheeler Join Date: Nov 2006
Location: Tring, Herts
Posts: 3,961
Thanks: 124
Thanked 173 Times in 124 Posts
|
Am I allowed to mention the "other" forum? If so, there was a thread discussing this very problem. All the solutions, and there were more than one, seemed to involve a little "bodging", shall we say.
hth Malcolm |
7th November 2006, 10:18 | #5 |
Newbie
Rover 75 Saloon CDT Auto Join Date: Nov 2006
Location: Cardiff
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Hi Mike
No. Just the visor itself falls out. I think Keith has soved the problem as there is no screw going into the fitting. Should a screw be there it would expand the fitting on the square plate and prevent the visor from falling out. I will check when I get home hopefully sometime this month (Been working in Palma for the last 4 months) |
7th November 2006, 10:19 | #6 |
Newbie
Rover 75 Saloon CDT Auto Join Date: Nov 2006
Location: Cardiff
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
|
7th November 2006, 11:51 | #7 | |
This is my second home
ZT400 Join Date: Oct 2006
Location: Ellesmere
Posts: 5,948
Thanks: 0
Thanked 43 Times in 29 Posts
|
Quote:
Go on then go and get the info for a howto |
|
|
|