Installing Hi-Line loom and boot components - how and where

biggles · 25th March 2008, 12:42

Hi all,

I am about to install a self-made loom for the Hi-line system in my LHD 75 saloon and have a few questions:

What is the best route I should use? The info I have come up with so far tells me to go:

1) From HU position
2) Past the glove box (right side)
3) Down inside the "outer footwell trim" (lacking better words - the one that sits next to the door and goes down to the carpet)
4) Under the carpet along the sills
5) Under the rear seat
6) Into the boot (right side)

Which leads me to the next series of questions:

How do I remove the various trim parts? Just by pulling them off? I also might need to remove both A and C pillar innner trims. Am I likely to waste fastening clips?

25th March 2008, 12:42	#1
biggles Loves to post Rover 75 2.5 V6 conn Join Date: Nov 2006 Location: Linköping Posts: 414 Thanks: 0 Thanked 0 Times in 0 Posts	Installing Hi-Line loom and boot components - how and where Hi all, I am about to install a self-made loom for the Hi-line system in my LHD 75 saloon and have a few questions: What is the best route I should use? The info I have come up with so far tells me to go: 1) From HU position 2) Past the glove box (right side) 3) Down inside the "outer footwell trim" (lacking better words - the one that sits next to the door and goes down to the carpet) 4) Under the carpet along the sills 5) Under the rear seat 6) Into the boot (right side) Which leads me to the next series of questions: How do I remove the various trim parts? Just by pulling them off? I also might need to remove both A and C pillar innner trims. Am I likely to waste fastening clips? __________________ /Erik [SIGPIC][/SIGPIC] Rover 75 2.5 V6 Connoisseur