|
||
|
20th July 2010, 15:02 | #1 |
Loves to post
Ford Mondeo Ghia X 2.0 TDCi Join Date: Jan 2010
Location: Langford, Beds
Posts: 353
Thanks: 0
Thanked 0 Times in 0 Posts
|
Union Alloys
Fitted my Union alloys today after many hours of cleaning as they were in a sorry state, but relativly cheap. the car is a lot better to drive not so soft around corners, but a little firmer ride over the bumps.
|
20th July 2010, 15:28 | #2 |
This is my second home
Rover 75 launch car x2, Rover 800 Vitesse Join Date: Jan 2009
Location: Plymouth Devon
Posts: 8,463
Thanks: 1,115
Thanked 1,083 Times in 653 Posts
|
|
20th July 2010, 16:52 | #3 |
Loves to post
Ford Mondeo Ghia X 2.0 TDCi Join Date: Jan 2010
Location: Langford, Beds
Posts: 353
Thanks: 0
Thanked 0 Times in 0 Posts
|
yes crowns fairly good nick as done less than 60000 miles, just had two new tyres on front! Much prefer look of unions but I must admit crowns give softer ride. |
21st July 2010, 13:40 | #4 |
Gets stuck in
Rover 75 1.8 Club SE Saloon, Rover 75 Tourer 1.8T Connoisseur SE, MG TF Spark Join Date: Nov 2009
Location: Staffs
Posts: 723
Thanks: 152
Thanked 44 Times in 39 Posts
|
Very nice! I've got the union wheels on my 75, they look superb when clean and shiney. Nice one!
__________________
-------------------------------------------------------------------------------------------------------------------------------- [SIGPIC][/SIGPIC] A Sucker for the K- series Engine Membership No. 987
|
21st July 2010, 14:55 | #5 |
Gets stuck in
Ford Kuga Join Date: Mar 2010
Location: Tatworth, Somerset
Posts: 734
Thanks: 1
Thanked 2 Times in 2 Posts
|
Yep - another Unions fan here.
__________________
Ex 75 tourer owner |
21st July 2010, 19:53 | #6 |
This is my second home
rover 75 saloon,cdt 170 bhp(ish) Join Date: Dec 2008
Location: maesteg
Posts: 3,150
Thanks: 6
Thanked 7 Times in 5 Posts
|
yepand me may change in the forseable for serpents
__________________
[SIGPIC][/SIGPIC][B meets and events in wales one event everyone should experience http://www.wolverhamptonnanomeets.com/ |
Thread Tools | |
Display Modes | |
|
|