|
||
|
8th October 2015, 11:52 | #1 |
Regular poster
MG ZT 190+, MG ZT 190 SE Join Date: Apr 2014
Location: Harrogate
Posts: 72
Thanks: 7
Thanked 7 Times in 7 Posts
|
17 pin connector
Hi all, had tha carpet out of the SE this week. Doing a few jobs including mending the Highline HK.
I have all the correct voltages now on the permenant, switched and K-bus. The bordmonitor won't power up. I assume this is because I have the radio tuner unplugged to dry out. The 17 pin connector in the spare wheel well that plugs into the radio tuner has corroded wiring and pins. The permenat live has completely snapped off where it meets with the pin. I am going to fit a complete plug with new wires for peace of mind. Does anyone know where I can buy the plug ideally with pins and a small amount of wire? The only thing I have seen is an adaptor which I could buy but it's a bit expensive just to start cutting up. I have heard of Farnell or RS components selling the pins and connector housings but I don't know any information about the connector or pins other than the MG Rover wiring diagram numbers which are obviously no use in this case. Any advice would be much appreciated. TIA, Rosswalki |
|
|