Passage coolant problems - Page 3

neilb740 · 3rd November 2014, 14:19

Quote:

Originally Posted by klarzy

oh.no.... it's much easier to use video..... you have seen "all creatures great and small" haven't you??

Mooooooooooooooooooo

All Creatures Grunt and Smell

And I suspect that applies to you at the moment

Paulym · 3rd November 2014, 16:28

This is a great thread I am so impressed.

Try a stainless exhaust to prevent corrosion. If all else fails a shot of Redex may assist with relief howevr for best results Terraclean application is recommended

ATB

FLYING BANANA · 3rd November 2014, 16:30

Nothing worse than having a blow back through your suck through tube.

klarzy · 3rd November 2014, 16:55

Quote:

Originally Posted by FLYING BANANA

Nothing worse than having a blow back through your suck through tube.

I was going to try the old solution of wire brush and carbolic salts, but apart from shining my tail pipe I did not think this would have the desires reduction in bottom end heating.

At the moment my intercooler rings are swollen to the point of popping out and splitting, as I do not want to blow my load in the garage I was going to try one of the AA's radweld kits...

Paulym · 3rd November 2014, 17:02

May be some gas flow engineering is in order with this particular problem. I could maybe suggest some Nik Wallender type antics to effect a complete clear through.

klarzy · 3rd November 2014, 17:09

Quote:

Originally Posted by Paulym

May be some gas flow engineering is in order with this particular problem. I could maybe suggest some Nik Wallender type antics to effect a complete clear through.

Afterburn is an issue here, I have seen some coil heat exchangers here but Boyles law dictates that gas under pressure is a stored energy potential which could come back to haunt me.

Paulym · 3rd November 2014, 17:17

Hi Karz
Sorry Klarzy

Some would be extremely jealous of an in built FBH. I have to put up with what some would term as second best heated seats.

klarzy · 3rd November 2014, 17:21

Quote:

Originally Posted by Paulym

Hi Karz
Sorry Klarzy

Some would be extremely jealous of an in built FBH. I have to put up with what some would term as second best heated seats.

Are they heated from below, or from "Within"???

whitevanman · 3rd November 2014, 17:24

Just thinking that tomatoes work for an over hot mouth when eating spicy stuff so perhaps try a few slices between your buns.

klarzy · 3rd November 2014, 17:25

Quote:

Originally Posted by whitevanman

Just thinking that tomatoes work for an over hot mouth when eating spicy stuff so perhaps try a few slices between your buns.

With a squirt of mayo no doubt....

3rd November 2014, 16:28	#22
Paulym Loves to post Rover 2.5V6 Connie SE (White Gold) Join Date: Oct 2013 Location: Rushden Posts: 378 Thanks: 166 Thanked 70 Times in 53 Posts	Brightened my evening This is a great thread I am so impressed. Try a stainless exhaust to prevent corrosion. If all else fails a shot of Redex may assist with relief howevr for best results Terraclean application is recommended ATB __________________ [SIGPIC][/SIGPIC] My own true Constance Boot Release Mod Walnut trims, Tail Light Seals & Torpedoes T4 Health check done (Thanks Mr T4 ) Real Walnut Dash (Thanks Paul D) Power Folds (one down one to go) Timing Belts Pump and Matrix Replaced (Phil T4) Bonnet release mod (Thanks Paul D) IPK De-lined (Thanks klarzy) New wheels (Thanks Paul D) Compensator, LED bulbs ABS Sensor and more(Thanks John H) Projectors (Thanks Paul D) Puddle light LED Strips Mods to do: Rear Spoiler?

3rd November 2014, 16:30	#23
FLYING BANANA Moderator/Club Shop MG ZT 1.8t+. No.3 of 4 in Sunspot Yellow & Ford Fiesta in Black. Join Date: Aug 2010 Location: Rattler Farm Posts: 22,568 Thanks: 9,270 Thanked 15,645 Times in 6,806 Posts	Nothing worse than having a blow back through your suck through tube. __________________ 233,431. That’s our second meet done, no.3 next weekend. onen hag oll

3rd November 2014, 17:02	#25
Paulym Loves to post Rover 2.5V6 Connie SE (White Gold) Join Date: Oct 2013 Location: Rushden Posts: 378 Thanks: 166 Thanked 70 Times in 53 Posts	May be some gas flow engineering is in order with this particular problem. I could maybe suggest some Nik Wallender type antics to effect a complete clear through. __________________ [SIGPIC][/SIGPIC] My own true Constance Boot Release Mod Walnut trims, Tail Light Seals & Torpedoes T4 Health check done (Thanks Mr T4 ) Real Walnut Dash (Thanks Paul D) Power Folds (one down one to go) Timing Belts Pump and Matrix Replaced (Phil T4) Bonnet release mod (Thanks Paul D) IPK De-lined (Thanks klarzy) New wheels (Thanks Paul D) Compensator, LED bulbs ABS Sensor and more(Thanks John H) Projectors (Thanks Paul D) Puddle light LED Strips Mods to do: Rear Spoiler?

3rd November 2014, 17:17	#27
Paulym Loves to post Rover 2.5V6 Connie SE (White Gold) Join Date: Oct 2013 Location: Rushden Posts: 378 Thanks: 166 Thanked 70 Times in 53 Posts	Make the best of it Hi Karz Sorry Klarzy Some would be extremely jealous of an in built FBH. I have to put up with what some would term as second best heated seats. __________________ [SIGPIC][/SIGPIC] My own true Constance Boot Release Mod Walnut trims, Tail Light Seals & Torpedoes T4 Health check done (Thanks Mr T4 ) Real Walnut Dash (Thanks Paul D) Power Folds (one down one to go) Timing Belts Pump and Matrix Replaced (Phil T4) Bonnet release mod (Thanks Paul D) IPK De-lined (Thanks klarzy) New wheels (Thanks Paul D) Compensator, LED bulbs ABS Sensor and more(Thanks John H) Projectors (Thanks Paul D) Puddle light LED Strips Mods to do: Rear Spoiler?

3rd November 2014, 17:24	#29
whitevanman This is my second home 2001 Connie SE CDT, 2002 2.0Petrol Laguna SportHatch Join Date: Jul 2011 Location: Althorne Posts: 3,122 Thanks: 319 Thanked 441 Times in 318 Posts	Just thinking that tomatoes work for an over hot mouth when eating spicy stuff so perhaps try a few slices between your buns. __________________ [SIGPIC][/SIGPIC] Today the 23rd of April I will mostly be: Kids, bikes, dog, kids, bikes, dog...Seems to be a pattern forming here Car: Connie SE CDT Manual, Mods: O-Rings, Silicon intercooler hose, Stainless EGR Bypass, BMW PCV Mod, 160 Upgrade, DD Unit, Projector Headlights, Powerflex Bottom Mount, Remote Clutch reservoir, SS Compensator; Inline Stat To Come: cat gut (when replacing iffy section). Meteors after refurb..