|
||
|
26th May 2014, 21:48 | #1 |
Owners Club Director
Rover 75 Conn SE V6 / MG ZT 260 SE V8 / MG ZT 180 SE V6 Join Date: Feb 2007
Location: Southampton
Posts: 20,965
Thanks: 645
Thanked 6,851 Times in 2,537 Posts
|
Trip Computer Option On High-line
Many people with early cars fitted with the High-line Sat Nav often ask how they can add the Trip Computer option to the main menu screen. The answer always given was that it needed a T4 session to enable this, but after talking to Phil T4 a couple of weeks ago I asked him how this was done. The answer was that it isn't a T4 programable item, it is down to the level of hardware and software loaded into the bordmonitor screen display.
So, I'd like to find out from high-line owners what level of HW & SW is present in their units to establish the switchover point when the Trip Computer data from the IPK started to be displayed on the menu screen. To find out what you have, do the following: From the main menu select 'Set' you'll see the following screen When you do, press and hold the MENU button on the head unit for 12 seconds This will then open the service menu screen below Select the first option 'On board monitor' and you'll be able to see the HW and SW levels To come out of this menu and return to the main menu screen, just press the Menu button again. The reading on all three of my cars is SW level 42, HW level 46, and Diag Index 11, Bus Index 09. They all have the Trip Computer option present on the menu screen. If you could post your findings including whether you have the Trip Computer option showing that would be great |
|
|