View Full Version : Technical Help Forum
- Interpreting MAF readings
- ABS issue
- HP pump rebuilt - Engine cuts out
- Torgue Setting on a wheel brace?
- Internal boot release
- ZT-T engine rebuild?
- Water leak, not sunroof, not scuttle clips??
- Radiator Bracket Repair
- Air bag light
- Front grille
- 2.0v6 petrol Battery
- manual gearbox gear selector
- Droning from front wheels
- Daytime running light wireing
- Twin horn loom help
- Mods Please
- Where to find the headlight washer pump feed
- Lack of working space!.
- Rear ABS reluctor ring
- normal running coolant temp
- Have I found the leak source?
- EZ-Cool Gauge - Wiring help?
- Bumper screw
- Diagnose fuel problems
- Mg zt aircon pipe.
- Rear right rigid brake pipe
- Symptoms of an over gassed air con system
- Air Con not working help please
- Retrofitting head light washers
- How do you use a clutch alignment tool?
- Air con
- ZT front springs, the garage can't compress them. Bit urgent.
- Petrol 1.8T Failing to Idle
- Engine mounts ?? movement when taking up drive
- Tourer rear seat back seat belt problem
- Fluid Leak
- Fuel pump relay
- No oil in gearbox
- tip for fitting Front Lower Wishbone Arm Bush
- Changing Clutch
- MAF Sensor
- Alternator/Starter refurbishment.
- Help! Facelift R 25 alarm wont stop ( pektron)
- Lower suspension arm choice?
- What bbus do I need
- Car will not start after clutch/slave change..zt-t 1.8t
- manual air con to auto
- K Series Engine undertray
- Help needed from diesel experts. Struggling to start.
- Fusebox Diagram
- Rear door fit in boot?
- Split charge relay question
- That lower rear engine Tie-Bar mounting. Questions.
- Front bumper needed
- Headlight bulb upgrade
- Aircon Compressor Clutch/Pulley Serviceable
- Auto gear box diesel sump washer size
- -30.0°c on IPK temperature display
- Help and advice required on clutch alignment
- Bonnet stuck
- Removing the Roof Rack GROMETS..?
- Electrical drivers seat issues
- 2 stroke engines
- Lower Front Grill Fix Needed
- Whining noise
- Tourer number plate bulbs
- MG ZTT 135CDTi, 2003 Front left door won't unlock
- Rear anti roll bar bushes
- Sudden Loss of Drive
- AC System vacuum or pressure test or both
- Help needed - 1.8 Petrol Non start
- ZT 190 Brake upgrade parts?
- Massive coolant loss V6
- Tourer hand brake
- Tourer rear shock replacement
- MG ROVER Build info
- Petrol to Diesel
- OBD 2 Compatibility
- Signs of leakage at bellhousing and hard to change gear when hot
- 2.5v6 coolant temp
- A puzzler for the tech gurus, not MGR
- No “how to” changing alternator on V6
- Water Ingress into Driver's Footwell
- Wheel Centres
- Brake pad warning
- What is best procedure for removing rear suspension upper arm
- Injector removal help
- Poor Braking
- Front suspension arm replacement
- K-series MAP / AIR sensor plug name
- ABS fault, cruise and speedo working
- Differences between pollen filters on Rimmer Bros...
- panic with slave cylinder pipe
- Power steering pipe bore size..
- ZCS and check sum codes
- HELP. charge fault, broken down.
- Tourer fuel leak
- airbag faults
- Sorted SWC's
- Changed window regulator - goes down ok, but goes up in short bursts
- Common locations for boost leaks
- Boot full of water!
- for and aft movement of belt on tension pulley Rover 75 2004 RJ 2.0 CDT
- Wheel offset question
- When to renew cam belts ?
- V6 screw up
- Did anyone ever get to the bottom of this?
- Mas filter screws.
- Front abs sensor change.
- Rds 7.0
- Air Con Compressor Failure????
- Spare Plug?
- Master brake cylinder Part SJC100410
- Cylinder 2 misfire -OBD code PO 302
- Suspension worn out?
- Rattly V6 on start up
- Air con help
- Spring Colour Codes
- Tow electrics help
- Time for new injectors?
- MG ZT KEYS etc etc
- MG ZT Suspension codes
- Retrofitting rain wipers
- Engine cuts out, Fuse 1 blows, odd buzzing noise...
- new drop links rounded flats
- Headlamp fixing and bonnet catches/cables.
- Aircon dripping, 2003 ZT 1.8T
- Tow bar fitting
- ZT rear subframe situation
- Reversing Camera
- ABS problems
- Seat frame problem
- Catalytic converter
- Clutch Master cylinder bleeding question
- Question for the 2l v6 people.
- Volumetric Alarm Sensor YWC 112250
- Volumetric Alarm Sensor YWC 112250
- Bonnet Locks
- alternator gone?
- loose injector?
- Should I use LPG plugs instead
- Windscreen leak
- Boot problem on saloon
- Wiring looms: Do all models have all factory options wiring fitted?
- Diesel single pump failure
- [SOLVED] Rear End Knock
- Chrome strips
- Which Front Dampers for my 54-Plate ZT-T 1.8T?
- Tensioner nut loose
- Clutch fluid capacity
- Rear suspension
- Webasto FBH few questions
- Gear change issues continued
- pleum help
- Airbag connection under steering column
- Blue smoke
- BCU settings lost again !
- Clutch Problems
- Injector refurb?
- Diesel overheating
- Spot welder socket requirements.
- New K-series Cylinder Head
- Self levelling headlamp sensor link - successful replacement that will not bend.
- Dieseln fuel pump test
- C-Tek Charger
- V6 no starter motor.
- New key fob. What am I doing wrong?
- Which rear springs??
- Airbag warning light
- Toaf connections and BCU settings
- Diesel Service
- ggrr how does cluth pedal spring fit
- Suspension struts
- taking my foot of the gas kangaroos rover
- Brake booster(?) and intercooler problem
- MLS question
- rattle when using aircon
- Blue Smoke - KV6
- Abgasgeruch im Innenraum / Petrol fumes
- VIS motors on Rover 75 2.5l v6
- Steering rack.
- CDTI randomly shutting down?
- sun visors with lights
- Self leveling problem - too high
- Do garages change all the ATF?
- Leaking rad.
- Bleeding the clutch advice please
- Inlet Manifold Gasket, advice please
- Creaking and groaning noise............
- airbag / steering wheel removal
- JeffD's door actuator post - missing photos
- Clutch Master cylinder condition
- Car stalled and won't go back into gear or even start in gear
- Still got a clonk, do these bushes look like they do the job ?
- Kv6 Cam Belt change Factory video
- Battery electrolyte escaped whilst charging.....!
- Rear Spring Compatibility - is it that critical?
- Rover 75 Tourer rear light fixing
- replace frontbumper
- ATF level plug
- Yes, Airbag light is annoying.
- front strut transplant from ZT 190 tourer to 75 CDTi Tourer
- BCU backup battery ?
- Really need some help/advice
- Front exhaust rubber hangers
- Fuel burning heater problem
- Front Strut Removal. Some Questions.
- 75 Diesel - Manual Gearbox Leak
- ABS sensor removal
- Bonnet Gas Struts? Magnetti Marelli.
- Rover 75 estate
- In tank pump gone again...?!
- Auto box solenoids
- help with my 190 please??
- Drivers pillar wet
- Heater not working
- Check engine light not turning on
- Traction control motor
- Key fob replacement
- CHG question
- Clunk from the front when hot
- Slight grinding noise under braking
- Rover 75 auto won't start..been sorn ed for a while
- Fitting AV lead from toysinyourcar.com
- Hesitation At Low Revs
- How to test a battery charger?
- Steering column disassembly
- brake duty solenoid
- Engine mount problems
- LHD Steering columns
- Suitable gear shifter or cables for early mk1
- Fitting rear sensors to 75
- Help with gear cable srpings, Diesel
- Diesel high pressure regulator seals
- Grinding Brakes
- Random Coolant loss
- My 75 Broken Into
- Cdti auto cruise control not working
- Boot automatic lifting
- Dead ATC blower
- MG v6
- Rear suspension upper arm.
- ABS problem
- DPF filter
- Zt v6 front downpipe and cat
- Wishbones
- Clutch problem not master cylinder
- 2.0 CDT Playing up!
- SOLVED - Power fold mirrors won't, ATC digital temp. goes from "22 C" to "Er"
- OBD 11 reader compatibility with our cars
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.