View Full Version : HELP !!! IPK Not Working
DaveyC
10th July 2014, 12:09
Just swapped my dials over (Thanks to Kalrzy).
All went well, until I plugged them back in and nothing!!! Not even a flicker out of the ignition light, or anything. Tried unplugging and plugging back in again....:duh::duh::eek::eek:
Out of ideas. Some helpful advice would be greatly appreciated chaps......
Edit: Indicators & Hazard's not working either :-(
Thanks,
Dave :duh::duh::duh:
suffolk boy
10th July 2014, 12:25
i did the same the plugs are not it fully. the horseshoe clip must be flat b4 inserting they go home with a clunk when in correctly
petespieces
10th July 2014, 12:33
i did the same the plugs are not it fully. the horseshoe clip must be flat b4 inserting they go home with a clunk when in correctly
Ditto, been there done that:}
suffolk boy
10th July 2014, 12:38
Ditto, been there done that:}
had that happen when i put trafficmaster.no indicators no warning lights etc.they are bit tricky due to the limited access.in think i put them in the sockets reached over the top and gave them a good push.
DaveyC
10th July 2014, 13:05
Thanks chaps!!! It worked. :D:D:D:D
I now have all systems working :D For a minute I was $@***ng myself there. Those plugs are a nightmare to to reach round and get in fully. :duh:
I'll start a thread on my new dials when i have stopped sweating :D
suffolk boy
10th July 2014, 13:12
i remember mine well.had to get a lift into work.when i finished in the middle of the night went out to the car tried again.hey presto it worked!i then hit the beer big time:}
DaveyC
10th July 2014, 13:14
Foolishly expected it to be a 30 min job. :duh: At least it fixed. :}
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.