Injector problem - need help!

[ashley101]

I've just started my first PCV filter change and run into a problem with the injectors... I've removed two as outlined in the 'how to', but only one will fit back in properly. The other refuses to go down fully.

They came out pretty smoothly and I can't see any blockage or distortion, but what's gone wrong and what do I do now? It's about 2mm from being fully home. Thanks...

[Greeners]

don't ever recall removing injectors to change the PCV

[ashley101]

Sorry, my mistake! I think I mean the t-shaped connectors that lead into the injectors?

[klarzy]

have you rolled the little o-ring off... make sure it is in it's little groove, then put the pin back in...

[ashley101]

Alright, sorry for the drama - this has resolved itself. It just needed a slightly firmer wiggle. :o

[ashley101]

Yes Klarzy, thanks - this was what was really confusing me as the o-ring was still in place and no plastic had been snapped off.

I was reluctant to force it after all the warnings to be careful, but fingers crossed it should now be okay. (I'll be posting back if it isn't! :} )

:duh: :duh: :duh: