Front Wheel bearing Dimensions

[andrewinpopayan]

Hi all.

Does anyone know the dimensions of a front wheel bearing? I think I have a problem with bits of missing signal segments on O/S/F.

I tried moving the sensor a bit but have always got a few pulses missing in the same place.
I am going to make up a press toolhead on the lathe to push the bearing in when it arrives, it can handle up to 3000Kg, no bash-bash with a hammer at £15 a pop.

Thanks
Andrew

[Tin Tent]

Have 1 in front of me now. 82mm o/s dia. 43mm bore and 37mm width all measured with a steel rule so could be 1mm out, hope you get on ok did one of mine in a vice won't do that again.

[andrewinpopayan]

Have 1 in front of me now. 82mm o/s dia. 43mm bore and 37mm width all measured with a steel rule so could be 1mm out, hope you get on ok did one of mine in a vice won't do that again.

Thank for that Tin Tent, I have a press for the job, I'll drop the bottom of the hub etc, remove the circlip and PRESS with some heat to get the old one out, I could probably use the old one to press the new one in after cleaning and greasing the hub.

Thanks a lot

Andrew