Bottom arm rubber bush

[pletevl]

Hi all, just been out to see if I could change the rear right side suspension arm bush and don't see how it is possible without removing the whole arm. Or am I missing something ?

Pete.

[KeirL]

Is it getting the two bolts out that's causing the issue or getting the bush off the arm once the bolts are out?

I've found these a lot easier once they've completely failed and the rubber has come away from the metal casing. If you get outer bit off then you're just left with the metal collet on the arm which can be carefully ground through with an small angle grinder (taking the appropriate precautions of course)

Hardest bit is getting the bolt holes lined up again when bolting the new one back in place.