View Full Version : KV6 Thermostat Straight Pipe Plastic Clips
Patrickmna
3rd February 2018, 12:24
So...What do those one time use fixings, knock off jubilee clips actually DO?
We may have replaced the thermosat without them and now I have an untraceable coolant loss....
maxi_crawf
3rd February 2018, 15:25
They stop the sleeve sliding up and down, it keeps the ends in the correct position in the water pump casting and the thermostat body.
Patrickmna
3rd February 2018, 16:45
They stop the sleeve sliding up and down, it keeps the ends in the correct position in the water pump casting and the thermostat body.
Ok I guess that makes sense, fortunately there is at least one still in position, I don't think the leak is coming from there. I suspect bottom hose but will know more tomorrow when I jack it up.
Thank you for your reply!
chris75
3rd February 2018, 16:57
Without them to act as a brace, "rocking" of the thermostat housing is likely leading to a cracked unit :eek::eek::eek:
Arctic
4th February 2018, 09:37
So...What do those one time use fixings, knock off jubilee clips actually DO?
We may have replaced the thermosat without them and now I have an untraceable coolant loss....
Hi Patrick
As stated above they are also re-usable you can open them side ways and reuse ;)
SD1too
4th February 2018, 12:04
... fortunately there is at least one still in position ..
As Chris75 says Patrick, you need both.
I don't think the leak is coming from there ...
Is there any coolant in the 'V'?
Simon
kaiser
5th February 2018, 03:55
They are belt and braces, but of no practical use if the pipe is installed correctly.
They are, in principle re-useable, but in practice they get brittle.
You can use hose clamps or cable ties if you wish.
I doubt your leak will come from from there.
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.