can i fit prt to my 1.8

[xantiaman]

hi all
im sure this has been asked before but i cant find it, i have a w reg 1.8 connie and would like to retro fit the prt system to replace the standard thermostat,is this possible?thanks

[T-Cut]

Theoretically it is, but obtaining all new OEM pipework will be either difficult or astronomically expensive. You've probably checked the layout on Rimmer's website, but here it is anyway: http://www.rimmerbros.co.uk/Item--i-GRID001582

I suppose you might get all the pipes from a dismantler/scrapyard.

If you go ahead, remember to substitute the 'dummy' thermostat (called 'flange') in the original housing. This is shown as Item 16 in this Rimmer drawing (the non-turbo drawing preceded to introduction of the PRT): http://www.rimmerbros.co.uk/Item--i-GRID001696

Also, don't fit the OEM plastic upper T-piece (Item 2). Instead order a Gerry-T in stainless steel. And use proper Jubilee hose clips throughout.

TC