walnut dash

[zola66]

Hi all,

I have just purchased a walnut facia that replaces the one round the heater dials and wanted to ask, is there a how to on removing the black plastic one as I have been unable to find it....:smilie_re:

[Scouse1958]

Hi this may help :)

http://www.the75andztclub.co.uk/forum/showthread.php?t=45529

[suffolk boy]

i used the guide on here and found it to be ok.getting the old out is easy enough but getting the new in has a couple bits that are a pain.the fresh air control cable will only locate if it is square to the fitting.some people i belive take it off the other end which allows more movement.the other bit is getting the passenger side air vent in .some one here managed to take a lump out of the dash and crack the walnut by hitting it.this is how i done it 1st feed in the top clip then slide in the bottom clip nxt to the mirror which just leaves the last one which you poke up with a screwdriver and give a gentle shove.dont be tempted to bend the clips upwards as it will only rattle and drive you nuts good luck