Reverse Camera problem

[Ajd1]

I have just fitted a Traffic master unit (the one behind the instruments) and now seem to have a problem.

The camera now shows a black screen, a black screen with a grey line down the right side, a proper picture with a bit of fuzziness or a picture like it should.

There doesn't seem to be any pattern as to which one will be shown next.

I haven't touched the double din or any of its wireing.

Is there any way I could have introduced any interference with connecting the traffic master CPU? There are only 3 wires to connect.

Not sure if it's my fault or just a coincidence.

Any help will be appreciated.

Andy

[MARKUK]

1st thing to do is remove what you put in and then re check the camera function. If there's still an issue, start trouble shooting the camera wiring

[Ajd1]

Will probably do that tommorrow after I've changed the brakes and go from there.

Thanks for replying.

Andy

[Mr Edd]

Is the camera hard wired or wireless?

The connections may have been disturbed when fitting the traffic thingy.

Edd

[Ajd1]

Sorry, should have mentioned its a wired camera.

Will check all the connections tommorrow as well.

Thanks

Andy

[Ajd1]

Went to getthe car out of the garage to change the brakes and the camera is now working.

It's not as clear as it was but there is only a slight fuzziness to the picture now.

Must have tried it a couple of dozen times and the picture came up everytime.

Wondering if I got any water in it from washing the car the night before.

If it doesn't get any better after a few days will have another look.

Thanks for the suggestions.

Andy