ICE replacement unit
Hi
2001 rover 75 connoisseur 2.0 CDT Does anyone have a wiring digram showing the wire colours to allow me to run a new loom FROM the "radio receiver unit" - in the boot ( per the rover factory manual )to the facia - to connect a replacement ICE unit Apparently I need to do this according to "dynamic sounds" (a firm recommended by this forum) Thanks |
The audio loom is connected to the main car loom via a BMW 17pin connector in the centre console behind the ashtray unit. It would be easier to use a BMW adapter lead (usually BMW to ISO) from there to the new unit.
|
Presumably if you have the boot-mounted radio module then your car has/had sat nav.
To fit a new head unit you will have to run a new coaxial aerial cable forward either from the radio signal booster on the c-pillar or from the boot to the head unit. |
All times are GMT. The time now is 20:18. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd