Raising height of passenger seat
I would like to increace the height of the passesnger seat in my 75 connie SE. The seats are electric - but only the drivers seat has height adjustment.
I plan to make up some 25mm spacers to fit under the seat mounting rails and then obtain some fixing bolts 25mm longer than existing. Has anyone tried this - and are there any problems that you would anticipate ? |
Why not try sourcing a LHD electric drivers seat, then both seats could be electrically adjusted to the right height:shrug:
|
Height adjustable passenger seats are extremely rare, myself and others have been after one for a long time, best bet is probably a drivers seat from a left hooker. Someone in France could make a good living selling second hand seats.
|
I have done the same mod ,
no probems what so ever just make sure there is a boss on either end of the spacer hth |
You could use spacers,or a stack of washers between the bottom of the seat rails and the body of the car,and use longer bolts.
|
Quote:
|
Thanks for the feedback. I don't think I need height adjustable seats, just a permanent lift to make it a little easier for my wife to get in and out.
Looking at the fixing bolts this afternoon I am going to need some with a similar flat head so the seat can move backwards and forwards over the top of them when fitted - just 30mm longer. Does anyone know where I might be able to get some from? |
You should be able to get them from any good hardware or Motor Factors.You need at least an 8.8 or preferably a 10.9 strength bolt.
|
Try Screwfix or Toolstation, they both have a good range.
|
wouldnt this cause problems at mot time?
|
All times are GMT. The time now is 15:42. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd