converting from single horn to twin horn
 

As my single horn is duff and I have a pair of twin horns and harness I thought I may as well convert to twin horns.

How/where is the harness run for the drivers side horn?

I have seen this thread https://www.the75andztclub.co.uk/for...highlight=twin but it does not at the moment suit my needs


thanks

macafee2

Hi Ian.
Remove the bumper, then the slam panel and swap over the loom and horns, the main loom plug is in front of the washer bottle.

https://i.imgur.com/pm6sKHvl.jpg1

while there check for any wiring chaffing on the arm add some protection.
https://i.imgur.com/vwWE4Pzl.jpg2

Put the slam panel on a work bench or ground, to help you remove the horn loom and route the new one the same way.
https://i.imgur.com/tp9N1ktl.jpg3

https://i.imgur.com/Mo1nMT5l.jpg4

https://i.imgur.com/zma4aU5l.jpg5

https://i.imgur.com/Q0nt46zl.jpg6

Once you have the panel off you will see how to fit it and the horns

Arctic, as always you come to the rescue. Thank you

macafee2

Also check the foam inserts in the bumper some need cutting for the second horn to fit.

Sent from my SM-P610 using Tapatalk

Steve, the main loom plug is attached to the inner arch by a plastic (PVC?) push-on clip/bracket.
1. Is there an easy way to detach the clip/bracket without wrecking it?
2. Have you found a source/supplier for the clip/bracket?

I think i just used the near-side foam as a pattern for the off-side one to cut out the space required for the second horn when I converted mine. Easy enough to do with a hacksaw or a sharp knife when I think I did mine.