Next Base Camera Fitting,
I have just got a Next Base 422gw Dash Cam, Question?. Which is the best way to reroute the cable to the fuse box, how does the A Pillar come off and once off
would there be enough room to push the cable behind and down under the dash board. Many Thanks. Rev. |
Best pulling off door seal and pushing cable in there.
You can remove trim but it’s clipped to dash at bottom end and as far as I could tell impossible to reclip |
It is OK to refix the A pillar trim, carefully not a problem.
|
Pull the a pillar trim outwards, then upwards to remove from the dashboard.
There is a gap you can get the wire through and down to the fusebox. |
Quote:
Did you read through al your hard wire thread? post 4 https://the75andztclub.co.uk/forum/s...d.php?t=313479 https://the75andztclub.co.uk/forum/s...276381&page=16 |
Quote:
Rev. |
Quote:
Rev. |
All times are GMT. The time now is 08:54. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd