Rear window brake light removal, Rover 75 Saloon.
Got a dead wasp stuck inside the rear window brake light. I've removed the 2 screws , how do I remove the plastic covers?
|
i have never removed or fitted one, but i have read about them being a problem to reseat . the clips apparently can snap like carrots. have a search on the google search bar above and read a few posts, before you attempt to remove.
|
Mine was hanging down when I bought the car about a month ago. A spot of Screwfix 'Sticks Like Sh*t' glue round the edge, with penny washers under the nuts a s well (the plastic was brittle and broken), all is now well.
|
i think the posts i read were about opening them up to see why some of the lights were not functioning , or working. yours was a straight forward re-attatch. might look out for some screwfix adhesive next time,always handy.. ;)
|
Quote:
Now you have removed the two cross screws. https://i.imgur.com/9m5BnfNl.jpg1 You gently pull unclip the small panel. https://i.imgur.com/bcjZ7snl.jpg2 Next remove the electric connector from it's clip. https://i.imgur.com/Eh8CoHUl.jpg3 Press in the connector tab and pull it apart. https://i.imgur.com/N0kAWL8l.jpg4 Now undo the two 8-10mm nuts holding the light to the plates stuck to the rear window. https://i.imgur.com/ERC1Fb6l.jpg5 You can now lower the unit from the window. https://i.imgur.com/npLjzR2l.jpg6 https://i.imgur.com/eV6pj9vl.jpg7 If any of the fixing break they can be repaired i have done an few. ;) |
Thanks for advice, done it now.
|
All times are GMT. The time now is 20:29. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd