What is this connector?
 

I was mucking around cleaning under the Bonnet the other day and I noticed this connector is very easy to remove, a little more digging and I found it should have a metal retaining clip which mine does not.

Anyone got any ideas where to source a replacement, it obviously hasn't caused any problems up to now but knowing it's missing is driving me insane. https://uploads.tapatalk-cdn.com/202...306e044dc5.jpg

Sent from my M2007J3SG using Tapatalk

im sure you would be able to buy something new online. if you can get a second hand one from a trader on here, with tail leads attatched you may be able to utilise the spring. if not then a quick solder job and heatshrink ....job done.

This is what the clip looks like. I dismantled this connector and all the rest when I replaced the head gasket in 2019.
https://lh3.googleusercontent.com/Az...-no?authuser=0
EDIT: To answer your original question, it's the camshaft position sensor wiring plug.
TC

Hi Shaun
I have a few plugs from different car looms, which plug type is it, 2 wires connector 3 wires etc.

Let me know and i will post one out to you FOC.

Ahhh Arctic, you are a star. It's three wire. Photo attached.

PM me your details and I'll happily pay postage or whatever you want.

Cheers

Shaunhttps://uploads.tapatalk-cdn.com/202...982322beeb.jpg

Sent from my M2007J3SG using Tapatalk

And that ladies and gentlemen is what this club is all about:bowdown::bowdown:

[QUOTE]Hi Shaun.
I have sent you a PM there is no charge so all i need is you to PM me your name and address ;)

As of today the springs two of one small & one large are ready for you tomorrow 27/9/21

I suspect one of these would have the clip , https://www.autoelectricsupplies.co....680/category/7

[QUOTE=Arctic;2901130]All received Steve.

Once again many many thanks, things like this make me love this club.

Got something to do tonight as everything else needs hours not mins and it's raining 😉

Cheers

Shaun

Sent from my M2007J3SG using Tapatalk

[QUOTE=FantasticMrFish;2901471][QUOTE=Arctic;2901130]All received Steve.

Once again many many thanks, things like this make me love this club.

Got something to do tonight as everything else needs hours not mins and it's raining 😉

Cheers

Shaun

Pleasure Shaun just don't drop it into the engine and then you have to remove the under tray, that's been done before by me too. :D