FBH controller gsm wiring
I’m just about to start the fit, quick question if I have this type of oem controller do I still need to run a wire to the FBH itself or tap into this loom?
https://uploads.tapatalk-cdn.com/202...9e60624af5.jpg Sent from my iPhone using Tapatalk |
Just tap into the harness from the timer.
|
I have not wired one to the existing timer but if it doesn't work note that the timer is just sending a signal to the relay near the fuse box and it is that relay which is directly connected to pin 3 of the FBH for the remote switch on and is connected to pin 4 of the FBH for your cabin heater to switch on as part of the process.
Please report back with your findings when you do the install |
Paused it for now, turns out the phone I’ve bought only has one output...
Sent from my iPhone using Tapatalk |
Quote:
That doesn’t matter, it’s just a signal! You can use it to switch on the fbh and the heaters, I did this on Debs ztt. |
Ahhh. So can I run a feed to the cubby, put it all in there, run it to the FBH controller and leave the existing auto on to the climate panel? I noticed today if I leave the climate on auto it regulates the blower until there is sufficient water temp.
Sent from my iPhone using Tapatalk |
All times are GMT. The time now is 22:39. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd