190 subframe
Good morning: i see that Rimmers have in stock ZT sub frames. Given the different transverse engines (260 apart) would what is advertised fit a 2002 190?
Thanks Steve |
Yes as you say they are all the same across the range except for the 260 so should not have a problem fitting.
|
Hi: thanks very much for the reply. Doesn't look too difficult a job in the Haynes manual - any tips? I would have access to a two post lift if and when the time comes.
Regards Steve |
It's a fairly straight forward job, hub pinch bolts could give a bit of grief, remove exhaust from manifold and centre rubbers and move to the side, steering rack bolts, and a few little bolts holding ac pipes, I did this on my back on the driveway so using a lift should be even easier!
|
Are front sub-frames prone to rust or are they being changed due to damage?
|
All times are GMT. The time now is 12:25. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd