At Last
 

Eventually got them both washed , polished and waxed...Just waiting now for the dreaded ! :eek:

Thanks, after checking here before i got her that was first question i asked. Daft question, how do i find build day etc info on my car.

Pop your vin in here http://www.mg-rover.info/get_info.htm

Will do, much appreciated.

Thermostat mod
 

Put the thermostat mod in Avril today. Now hopefully save a few quid on better mpg. On a side note I noticed the inlet ports full of soot, so booking in for a terraclean soon. Oh and restored the headlights on thursday.

Changed A/C belt
 

Today changed the A/C belt on my ZT CDTi.

As can be seen it was a bit worn. Not a bad job to do as long as you have the dealer tool.

http://imageupload.co.uk/images/2018...SC_1733.md.jpg

http://imageupload.co.uk/images/2018...SC_1732.md.jpg

http://imageupload.co.uk/images/2018...SC_1731.md.jpg

Oh yes, just a shame i waited so long to get one.

Now't really, wet and raining here again :duh: managed to put a couple of fixings in my front splitter but then gave up.............so the POL/Gaydon clean has not happened.........On a course all this week so going to be tough to get the time for a good cleaning session :shrug:

A couple of tip runs and was hoping to look for the boot water leaks but seeing as it’s started raining I’ve just put some talc in the boot. In between showers I’ve been looking for the source of an annoying rear rattle, fingers crossed that I might of worked it out!

Started at 08:30 this morning shampooing both cars. Had a break then went back out and clayed Mo, followed by a super resin polish :D
All done at 16:00