Premium bumper indicator bulb replacement
My passenger side MG ZT indicator bulb has blown and needs replacing. It has a premium bumper fitted, do I need to fully remove the bumper to replace it? Any advice would be appreciated. Thanks.
|
Quote:
Brian :D |
I would assume it’s the same way as my mk2 ZT. Remove the small piece of trim underneath each front corner (attaches from front of each arch liner to base of bumper. It’s 3 or 4 screws, move the plastic piece out the way, reach up and twist off indicator bulb holder which should have enough wiring to hang down clear of bumper.
|
Thanks very much, it will save me having to remove the whole bumper. 👍
|
Lenses are removed from the front.
|
Quote:
|
Quote:
Long time since we have seen you at a meet, and it will most likely stay that way with this C19 ongoing, hope you are well link below, with some photos to see if yours is the same. https://the75andztclub.co.uk/forum/s...ht=MG7&page=19 They should just clip out as here below in this link. https://www.the75andztclub.co.uk/for...d.php?t=304221 |
Quote:
|
Quote:
Gail says hello back & to keep safe try the link now Steve. https://the75andztclub.co.uk/forum/s...ht=MG7&page=19 https://the75andztclub.co.uk/forum/s...&highlight=MG7 PS pop a photo up of your bumper |
1 Attachment(s)
This is it. Hope photo is attached. Attachment 83288
|
All times are GMT. The time now is 12:42. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd