Fbh
Hiya, I've just tried to activate the FBH via text message, sending RT.
The heater fires up and runs for about 20 minutes as it should but the blower isn't kicking in at all which it should after the heater has been running for 5 minutes. Am I doing something wrong? Cheers, Dave |
hi there
before you turn your car off have you left the heater on it should be so that when you take your key out it turns off then it must be left in this state so as you say after 5 mins it turns it self on when you send text if you already do this and it dont work then it not right hope this helps am sure the main people who do this will explain more regards paul |
I thought activating the cabin fan, is this is what is meant by blower requires additional wiring.
Activating the FBH does just that, activates the FBH which only heats the engine coolant.....so I understand macafee2 |
Quote:
|
Quote:
|
Quote:
That would be a good result macafee2 |
The GSM units have 2 relays, when you send a text relay 1 switches on the FBH. If it is programmed correctly relay 2 will come on after 5 minutes and switch on the ATC in the car but yes the ATC has to be left on when you switch the ignition off on the previous occasion the car was used
Additional wiring back to the ATC is needed and there is a how to on this forum which gives the detail. One word of warning is that some of the early GSM units sold by the seller who supplied quite a few to members on here were faulty and relay 2 did not work so that is always a possibility to consider, which can be overcome by using a timer relay. |
Your text messages to the GSM should be:-
R1on this will start the FBH regardless of the outside temp R1off will turn it off again R2on will turn on the ATC unit R2off Will turn off the ATC unit ZZ will start the process of first starting the FBH. It will run for 5 minutes then the ATC will be turned on. They will both run for 20 minutes then shut down (to avoid flattening your battery. ZS will stop the sequence. REMEMBER, it is important that if you use R1on or R2off for testing purposes, you must turn it back off with the R1off or R2off command or it will stay on indefinately. There is no 20 min timer on these settings. I just leave my ATC in the auto position and never turn it off anyway. |
All times are GMT. The time now is 12:34. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd