##Urgent help##
I have just fitted the inline thermostat and now have engine warning light on and can’t get above 1000 revs need for work this afternoon any ideas??
Sent from my iPhone using Tapatalk |
Could it be the wrong way round? Is there still enough coolant in there?
|
You may have disturbed something whilst changing it over where in Ayrshire are you?
Try disconnecting your maf. |
I’m in Kilmarnock and fitted as per your nstructuon with brass part towards engine, topped up tank with coolant and used bleed screw until steady flow
Sent from my iPhone using Tapatalk |
If you removed the manifold make sure you plugged the MAP sensor back in and the fuel rail sensor, both of these would trigger the engine management light, MAP SENSOR is fitted on the drivers side of the manifold and is often overlooked when putting stuff back together.
Oh I just remembered I’m supposed to be on my holidays lol:cool: Mick |
Yes both are connected
Sent from my iPhone using Tapatalk |
Hi, you could check and clean the connections to the MAP sensor and fuel rail.
|
try a battery reset for 10min
That will reset the ecu and if it was anything serious it will come back again if not then dont worry. |
Done the battery reset now all good thanks everyone
Sent from my iPhone using Tapatalk |
|
All times are GMT. The time now is 23:21. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd