Hi all, help required re my new 75
 

Hi all, not been on for a while but my 75 has now become 2 75s

I saw this red one heading for breakers, it’s far too good for that so I have saved it

I do have a few questions but I will start with the fob, it won’t unlock the car at all, any doors, but will lock it

I have tried re connecting the fob, the red light doesn’t illuminate when I press open but does on close

I assume the fob is dead? If so we’re can I get a replacement from near Doncaster ideally?

I am hoping to use this toad system to as I have failt code p167 whatever that is!

Thanks all, any help appreciated

http://https://share.icloud.com/phot...GGXw#Doncaster

Guess you mean TOAF - seen auto correct change the name a few times.

Have you just the one key? You could open up the keyfob and spray some contact cleaner on the two micro-switches, even try pressing the switches once exposed as it's possible the keyfob plastic isn't engaging correctly. A different s/h remote board is a possible solution too but you'll need to get Toaf up and running first with version .43.

Sorry, think your fault code might be missing a digital, usually a four digit code after the P.

Regards

Hi Iain
sounds like you need a new circuit board in your remote, Not a problem to sort out, If your code is P0167 then it is the lambda sensor, check the wiring to the rear sensor near the heat shield as ive seen a few where it has chafed through

Dave

Try Jamie
 

When I had real fob problems I sent it to club member Jamiewelch . Excellent service. He has also helped me out on other things . Try him.
All the best.
PS - thinking of saving a local , blue 75 myself but will have to overcome the boss here at home first because she says I have too many already!

Hi all thank you so much!

Firstly I’m sorry my code is P1637 & p0000??

I have tried to use the remote without the case but still
Nothing

I’m
Currently having the toaf uploaded onto my laptop, I’m ok with engines but not technical lol

Do I need to pay to do this? And could I use another fob if that makes sense?

Thanks all loads

I saved this from the breakers but sadly I have to sell it on

How do I upload a phone picture please?

Quick update

I cleaned up the pcb, it worked but the drivers door didn’t open? Opened rest but then it’s stopped working again

Best thing to do Contact Big russ he'll sort the key fobs out for you and can put the car on the T4 system very helpful only lives in Leeds area

Again for Russ (BigRuss) in Liversedge, only an hour away.

P0000 is saying no trouble codes generated and P1637 is flagging a connection fault between the ABS sensor and the ECM so a CANbus fault - you will need to check the wiring between the ECM and the ABS sensor.

P1637 Can Link ECM/ABSCM Circuit / Network Malfunction