Refitting wheel bearing
Okay stupid question but what way https://imgur.com/a/Y4bHgIKdoes the new bearing fit and can I put any grease to help it go in ?
Thanks Got it |
the first image shows the reluctor ring face side. this side needs to go towards the abs sensor face.
|
should be only a very light film of oil.will be a tight tollerence fit that needs to be on a press ideally. its got to be square and pressed in correctly without bearing damage. not at all an easy task without care. so be very carefull. it can be done with care and thought but a local eng place would do it in seconds and may save you buying another bearing !!! :D
|
Quote:
Thanks |
check out the posts on here on google search for fitting front wheel bearings. the inner race has to be supported for pressing in and ideally needs spacers of the correct sizes to achieve this. some have managed to fit them with a vice and other means , but a press is really what is required. im sure you could take the hub to someone and pay a small fee , rather than risk trashing the bearing and then doing the job twice ,in costs and time. worth thinking about .... ;)
|
Thanks all I dropped it off to a local garage with a press
|
Quote:
|
oh, and dont forget the 14LB hammer ... :duh:
|
Quote:
|
All times are GMT. The time now is 07:00. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd