Rear light unit
 

Wanted rear light unit for a tourer all the clips are broken on mine. Please and thank you https://uploads.tapatalk-cdn.com/202...63e8fe1ee2.jpg

Sent from my SM-G780F using Tapatalk

You can get a refit kit from eBay, search for bizzy Lizzy on eBay ��

https://www.ebay.co.uk/itm/134180304...sAAOSw96thZWQX

[QUOTE]Hi Ron.
The above will make no difference if the light lugs are broken :eek:

https://i.imgur.com/IBKkDE4l.jpg1

https://i.imgur.com/vUB8EUyl.jpg2

https://i.imgur.com/gSCvhudl.jpg3

Then you need to repair them ;)

https://i.imgur.com/BrAMQTFl.jpg4

https://i.imgur.com/ZPISYuol.jpg5

https://i.imgur.com/vbUdCmKl.jpg6

https://i.imgur.com/UCeT5R7l.jpg7

And use new fixing that will never need changing again.
https://i.imgur.com/pOg8c9vl.jpg8

https://i.imgur.com/adKBcVrl.jpg9

https://i.imgur.com/3EsbpP3l.jpg10

Use stainless steel screws to fix light later after repair.
https://i.imgur.com/IHwuFMvl.jpg11

https://i.imgur.com/jnmRb5Ql.jpg12

Ah right Steve:bowdown: Cancel that then:D

Ron they will still work on the pimple heads, but may need a little work with a 5mm drill bit and some vaseline, they go brittle quick so opening them a little makes them last longer ;)
https://i.imgur.com/G1iRPVAl.jpg1

https://i.imgur.com/rMd9Czhl.jpg2

https://i.imgur.com/iChT4BUl.jpg3

https://i.imgur.com/dTqEjqjl.jpg4


https://www.the75andztclub.co.uk/for...63#post1253363

How wide is the hole in the body that is created at the factory?
The hole I am referring to is picture 9 in post 3

macafee2

Hi Ian.
I think it's 8mm or 10mm can't remember now :duh:

Thanks very informative. I'll get the kit and getting mending

Sent from my SM-G780F using Tapatalk

I bought the ebay kit, although I haven't used it yet, as I still need to remove the remains of one screw. The plastic sockets have been redesigned, apparently.

When I did the other side, I bought some sockets from X-part. I had read about using a 5mm drill to open them up, but when I measured the ball on the lamp, it was less than 5mm, so I didn't. What I did do was drill a 1.5mm hole at the base of each slot. I'm hoping that will reduce the possibility of it cracking.

https://www.the75andztclub.co.uk/for...e61421ca97.jpg