Thermostat elbow pipe
Hi All, I've just removed (keyhole method) the KV6 thermostat and elbow pipe and unfortunately there is still a bit of the elbow stuck in the block. Is there an easy method/tool to get the remains out.
Thanks Michael. |
Sadly not. you cannot really see what your doing. You could by feel, risk it and try to clean out the old plastic and whatever else with the help of a mirror and torch , but given the hassle ,i would remove the manifolds. the plastic will be well crusted in ,and whatever yo do , dont use a metal object to prise the plastic away. you will dig into the soft alloy and compromise the seal wall. the whole set front and rear manifolds can be removed as one piece , without disturbing the fuel lines and making the job easier. new gaskets are advised upon refitting. if you feel lucky then try your luck in situ , as you are , but as your half way dismantled already i would finish the job making certain all is ok. The inlet manifold gaskets will need renewing if you do decide to do it though. depends on how long you are prepared to wait for gaskets (next day can be arranged for delivery ) .... good luck. ;)
|
:iagree::wot:
Very easy to slip and score the bore without optimum access. |
Heat up a woodscrew and melt it into the remains of the pipe, let it cool and pull it out.
Sent from my SM-G780G using Tapatalk |
i use a thin piece of wood as a lever
|
Quote:
Very good advice from xsport above noting that you'll only need one inlet manifold gasket as the RH bank manifold can remain in situ. Simon |
Mike
How are you getting on hopefully you now have the broken part out now, If you are going to dismantle the inlet system to gain better access to it be very careful as you can very easily break some of the plastic fuel lines and damage the injector o rings I have done loads of these by the keyhole method and easily got the broken parts out and have never had to remove the manifold if you are stuck send me a PM, Had you been nearer to me i would have gladly come and removed the broken part for you Dave |
Having had a manifold to head gasket fail on the road I always remove the manifold and replace the gaskets when changing a thermostat as a matter of course.
As mentioned above it is easy to remove the manifold complete with injector piping. When I do it I use a couple of nylon wire ties to hold the two manifold parts together to avoid stressing the pipe connections. |
Quote:
Sent from my CPH2371 using Tapatalk |
Job completed. Took me a while but I have large hands.
If it fails again I will be removing the manifolds. Thanks again to all for your advice on the key hole method and removal of the broken pipes. |
All times are GMT. The time now is 21:28. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd