install 2nd hand ipk message centre
Hi,
I have a 2nd hand message centre ipk and the stalk to replace the basic ipk Does anyone have advice on how to install them? Is it a T4 requirement? cheers |
Yep, need to get a T4 involved to "virginise" the eeprom in the "new" IPK and transfer info from old IPK. I think it can be done with TOAF, someone who knows TOAF better than I do should be able to advise.
|
is it just an ipk or the whole thing, rev counter, speedo and gauges?
easy to replace the whole thing. remove the eyebrow above the existing clocks, 2 screws. There is then 1 screw centre top at the back holding the clocks in place. Remove this screw Clocks will then come forward, may need some force. I found if I pulled the dash board forward it was easier to get my hand behind the clocks to push them out. There are two plugs at the back of the clocks that need to be removed. before reprogramming "new" clocks just plug them in to make sure the ipk is good but you will need to fit new stalk first. to replace the stalk. remove the two screws holding the shroud over the steering column. Once apart you should see two screws holding the indicator stalk I place, once these are removed withdraw the indicator stalk from a square box and unplug wiring. refit is just the reverse. macafee2 |
Quote:
|
Quote:
still an easy job. macafee2 |
All times are GMT. The time now is 10:49. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd