Loud crack sound when opening drivers door
When I open the drivers door I am getting a loud crack sound.
The same sound as if the door or wing has been hit and the front edge of the door is hitting the wing or chassis. I have tried WD40 on the top arm that stops the door opening to far but that has not worked. Do I need to remove the door card and membrane to access anything inside the door? Any tips on solving is appreciated. thank you macafee2 |
It’s the door check strap coming loose or seizing up, check the two 10mm headed nuts that hold it to the A pillar and get some grease in there!
|
WD40 is NOT a lubricant. It is a water repellant. Try some proper oil or grease on the hinges etc.
|
Water Dispersant.
Useful in the old days of ignition distributor caps, should have pased into history when they fell out of use. |
|
Quote:
|
Quote:
|
Quote:
|
Originally a T21 350cc, now a T100r 500cc top end with a single carb
|
Quote:
D*mn, beat me to it :duh: I was going to guess T110 - didn't think of the smaller lump. Pistons look higher comp than normal...? PS you have to get the grease further in than you can see :) |
All times are GMT. The time now is 15:28. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd