Harman Kardon Amp schematic required
Hi, can anyone help with a schematic of the Harman Kardon amplifier, I have changed the speakers in my sub and doors but the amps are set up to match the factory speakers response. I would like to be able to try and adjust them to the new speakers. I know there are different versions and I have two, interestingly one has eight amps, two for the sub, four for the doors and two spares that aren't connected to the pre-amps, anyone know what the idea was?
The other one only has six amps fitted. |
the HK amp has DSP to set the EQ, crossovers and limiters (speed and level dependent)
unfortunately it's not possible to adjust unless you have the interface box and software from Harman, |
Thanks but I don't think these are programmable, there are ten BA14741 quad op-amps, three or four TA8233H power amps depending on the model, a TIP32C transistor to switch the power on and off and 7 small signal transistors scattered about. One op-amp buffers the four inputs and splits them between the four channel filters and the sub woofer drive which combines them into another op-amp that forms a low pass filter.
I've been toying wit the idea of using the BMW DSP amp but that will need more wiring to the doors and they don't seem too impressive on the BMW forums, not to mention expensive. |
All times are GMT. The time now is 05:21. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd