Help needed with seat bolt remover
hi can anybody give me a link to which ever tool i need to remove security seat bolts.tried every thing i have but without success.cheers for any help.
|
If you are on about the bolts that secure the runners to the floor. They are just a T50 torx bolt IIRC
|
Quote:
|
I've seen many posts that say that this is a T50 Torx head, and only one that said it was a Ribe head.
I have recently removed the seat runner retaining bolts from my drivers seat and after rounding off one of the bolts with a T50 Torx (it was very very tight), I bought a Ribe set from ebay for £13.95 link. I then used the 8mm Ribe bit to remove the other 3 bolts without incident. I'm certain my car has 8mm Ribe bolts fitted. It seems to me that the T50 will work on bolts that are not as tight as those on my car - but I believe the 8mm Ribe is the correct bit to use. I would suggest that if you use a T50 make sure you have very good downward pressure whilst undoing the bolt. Tommy :-) |
Quote:
I've not come across a Ribe drive before and Wikipedia has no references to it. They are available on eBay and from there I put together this graphic showing the similarity between three hex-splined systems. http://i5.photobucket.com/albums/y19...ine_Drives.jpg The Polydrive looks even closer to the Ribe than the Torx and it makes you wonder if they're the same system. The Polydrive has rounded spline roots whereas the Ribe is seemingly square. Both are for high torque applications. The upshot is you need to examine the bolt head carefully to determine which drive system it uses. Using a Torx driver in a Polydrive bolt will almost certainly damage something. TC |
5 Attachment(s)
Quote:
|
All times are GMT. The time now is 17:10. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd