ZT Spoiler
does anyone know how the ZT spoiler attaches to the boot
https://rimmerbros.com/Item--i-GRID001805 i have these already https://rimmerbros.com/Item--i-DYH100870 just wondered if i need anything else on that first link? i was thinking it needed https://rimmerbros.com/Item--i-FS106307M anyone help? |
3 Attachment(s)
Quote:
Remove the two rubber grommets and behind them are one 10 mm bolt each side (they normally snap out of the spoiler so be careful) them will see two 8 or 10mm at the edge of the boot lid. Undone all them and pull as it’s also stuck down with foam tape. I have fitted one my self it’s not hard job |
Oh you mean the lip spoiler that’s a simple job take 10mins
|
i mean what do you use to attach the spoiler under them rubber grommets?
Screw-nylon patch - M6 x 30 - FS106307M ? |
You mean the small spoiler that holds the rear number plate lights?
That is held on by four nuts inside the bootlid recess. You need a small extension to reach them properly.A bit fiddly because you could drop them into the bootlid. |
Quote:
Cheers, Glenn |
thanks all for the help, but i need to know how to attach the back of the spoiler and the part on rimmer bros website or can i get away with just getting a 10mm bolts from the local shops
https://i.ibb.co/GscXVcS/ztspoiler.jpg |
going to try and get some M6 x 30mm bolts tomorrow see if they fit
|
Quote:
|
|
All times are GMT. The time now is 12:39. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © 2006-2023, The Rover 75 & MG ZT Owners Club Ltd