O-ring sizes thermostat KV6
 

hi guys,

i am in the process of replacing the thermostat housing and it has gone pretty well. i even got the bendy bit off without breaking anything.

i replaced most of the inlet to the point where i could refill the system and lo and behold: the O ring of the pipe bit is just pouring out coolant when filling despite cleaning it and lubing it up before putting it all back.

does anyone had the sizes of the rings that are used on the 90 degree pipe and the straight pipe so i can source new ones locally?

buying a kit from rimmers for example is not really a option for me as it takes WEEKS to get stuff shipped over if its held in customs and the taxation makes it a really expensive set of o-rings if i did....
and no, i cannot find these parts in holland. even getting the thermostat housing was already a chore.

ps: i just noticed that i posted in the wrong place, can a moderator please move it?

Hi Mark,

Customs? You confused me there because your profile says you're in Essex! :confused:

Anyway, the Netherlands it is. Here are two suppliers which have CDU 3858 in stock.

1. Company name Auto Rega BV
Address Morsestraat 13
Postal code 6716 AH
City EDE
County / state / province
Country Netherlands
E-mail [email protected]
Telephone +31 (0)318 648191
Managing director R. Gans
Legal company name Auto Rega BV

2. Company name Damen en Kroes Boxtel BV
Address Schouwrooy 14
Postal code 5281 RE
City Boxtel
County / state / province
Country Netherlands
E-mail [email protected]
Telephone +31 411 688 088
Managing director A.E.H. Damen
Legal company name Damen en Kroes Boxtel BV

Good luck!

Simon

PS If you prefer to find your own the ID is 32.5mm and the cross section 3 mm +/- 0.1 mm.

Thanks for the info. I will see what i can get faster. I need to get the car going asap.

Ps: google the adress, its a very specific location in britisch history. :}