absolute doddle, remove back bumper cover, 5 scrivets under boot seal, 2 underneath at centre, then one self tapper on bottom of bumper at the wheelarch end. Remove the crash bar and retain bolts, the towbar crossbar bolts onto the back of the car using the crash bar mounting holes and bolts, there is a plate that bolts onto the towing eye of the car, then there are bolts which go through the boot floor and chassis leg and the holes of the towing bracket. drill a hole in your spare wheel well to allow the wire to be passed through, replace bumper cover, fit towball, torque to specified settings, job done,. As for wiring, I just used snap connectors, but some prefer to use a relay. I have the wiring colours for the car, and the 2 lots of 7 core ,if you are fitting both towing sockets. If its the single 13 pin socket, can't help.
