Quote:
Originally Posted by The Mighty Quinn
OK, NOW THE REAR 2 BUSHES:
I had 4 of these individual bushes lying around for a while, so I've taken photos of one of those (instead of those in-situ)...
DEPTH (including steel lip): 56mm.
OUTER DIAMETER (at bottom): 56mm.
OUTER DIAMETER (at top): 57mm.
STEEL BOLT HOLE - INNER DIAMETER: 10.5mm.
STEEL BOLT HOLE - OUTER DIAMETER: 20mm.
IMAGE 1: DEPTH.
IMAGE 2: OUTER DIAMETER AT BOTTOM,
IMAGE 3: OUTER DIAMETER AT TOP.
IMAGE 4: IMAGE SHOWING THE TAPER OF THE BUSH.
IMAGE 5: Steel bolt sleeve outer diameter.
Cheers,
Karl.
|
Hi Karl,
Sorry to say, but it seems that all your measurements are wrong when looking on your pictures. The measurements shall be read from the "0" line on the "slider" against the scale on the caliper, not from the edge on the "slider". You are basically 3-3,5mm out on your values. A plastic caliper should also be banned, a steel ruler would even do a better job. A proper steel caliper will give you accurate readings in 0.05-0.1mm increments:
http://www.technologystudent.com/equip1/vernier3.htm
