Quote:
Originally Posted by SD1too
Sorry for the delayed reply Jake, I had to go out.
If you heard the control box relays operating then that proves that the PCB is OK. The fault must lie with the motor or its wiring. We can check this too: - Identify the centre relay, the one with the thick BLACK and GREY wires on it.
- Remove the connector with the two BLACK wires attached.
- Perform the next stage positively and quickly. Be prepared for some sparks. You don't need the ignition on.
- Briefly touch the removed connector with BLACK wires attached onto the GREY wire still connected to the relay. The motor should run at slow speed.
Simon |
Simon I will await any info any time.
Simon yet again I cannot thank you enough
.
I will try this tomorrow and report back as now clean and tidy to go out and the missis will kill me.
