75 Tourer cdti hydra(o)mount
Hi, while taking out the HPFP prior to putting in the recon HPFP (from P F Jones) I found the hydramount (or is it hydromount) was leaking. It fell apart taking it out.
Bought a replacement from DMGRS and plan to fit it tomorrow. I don't have the special tool but plan to spin it in with with a bit of threadlock on and then tighten up with couple of taps with a copper drift. Then use the torque wrench on the top nut (will check book for torque on that). I'm assuming that by the time the "cap" over the top hydramount stud is tight against the top of the hydramount then it won't spin and stress the rubber.
Bit expensive to stuff up!
Any thoughts?
JohnnyBG
|