Quote:
Originally Posted by ashy90
I have searhed for this but couldn't find a guide with any photos etc.
I have a 2000 Rover 75 saloon and a 2002 MG ZT saloon. Both have water leaking in to the boot from the rear window trim clips.
Firstly, there is no way I am having the rear glass removed on both cars to reseal in some new clips.
How is the trim removed? If some clips break then surely the trim can be re- fitted with a couple of blobs of sealant? I've seen windscreen fitters do this to A pillar trims when clips have broken.
I've got some Creeping Crack cure as recommended by someone on here. I've got some silicone on the way to me too.
Any advice or photos would be much appreciated.
|
After waiting months have just done this job last week
1. Remove the upper boot lid seal - that's the black flexible strip just below the rear screen glass
- open boot lid
- start at an end (either), raise the flap and locate the first clip. Grip the flap with both hands thumb and index finger (thumbs about 4" apart and grip as close as you can get to the steel spine of the flap), gently pull down and towards you so you can see a 1-2mm gap open between the flap and the window trim (I found resting the hands on the main boot seal gives a good purchase) and give a firm, gentle upward tug - this should disengage the serrated tags (you'll hear a rasping noise) of the clips (male tags on the flap and female on the fixed clips). Now repeat the same process until all the clips (x8 I think) disengage and the flap can be removed.
2. Lift the lower section of the rear screen trim
- start at an end, it's now apparent where the clips are (NB at the ends, where the trim starts to curve upwards to the sides of the glass you'll see a 'floating' clip-like spacer attached to the trim which prevents it being depressed/dented where it's unsupported by a clip - you don't need to disturb this).
- adopt a similar process to removing the flap, grip the trim (not as much to get hold of here) and gently pull down and towards yourself (look for a small outward movement of the trim in respect to the fixed glass screen) and then a light upwards tug should release the trim from the clip (again you should hear a rasping sound) and just repeat for each clip
I didn't break a single clip and don't forget, for disengagement all you are looking for is 2-3mm of lift.
I chose to replace all the clips with new items (a bit more of a fiddly job) and opted to position them with a polyurethane sealant rather than just rely on the foam seals and mechanical fixing to keep the water out.
I'm waiting for some more clips to arrive so I'll take some pictures when I've finish the task.
Best of luck